RTF-Code displayed in ReportBuilder

svenheuer · Post by **svenheuer** » Tue Aug 14, 2012 1:03 pm

Hi,

using Delphi XE2 (32 Bit Project), I converted HTML code to RTF with the HtmlConverter and saved this in a CLOB-Field. Everything looks good.
If I run my ReportBuilder (14.05) and connect an Advanced Richtext Component to this field, I see only the RTF-Code (and got a lot of AVs). I can open the RTF in Word and Co and everything is ok.

The demo project runs also well.

Do you have any hint, what may be going wrong here?

Sven

Post by **Sergey Tkachenko** » Tue Aug 14, 2012 1:04 pm

What version of TRichView?

svenheuer · Post by **svenheuer** » Tue Aug 14, 2012 1:22 pm

The wrapper has the Version: 1.14.2

Post by **Sergey Tkachenko** » Tue Aug 14, 2012 1:26 pm

If you use TRichView 13.11, download TRichView 13.11.1

svenheuer · Post by **svenheuer** » Tue Aug 14, 2012 1:29 pm

I have 13.11 - downloaded a few hours ago...

I read that the current version is in the protected area here but I can not find it!

Post by **Sergey Tkachenko** » Tue Aug 14, 2012 1:32 pm

It just was uploaded. Download from the same location

svenheuer · Post by **svenheuer** » Tue Aug 14, 2012 1:45 pm

Magic. Much better.

On pages where in the RTF is a picture embedded the ReportBuilder hangs for round about 1-2 minutes and than there is there RTF-Code code again. But may be there is a problem with the HTML-Converter. I will check the code.

But thanks for the fast update

Sven

svenheuer · Post by **svenheuer** » Tue Aug 14, 2012 2:29 pm

it looks that the html-converter has problem with german diacritical chars like ä. Our preprocessor does not convert these chars to the correct html entity. May be this will solve the problem.

Post by **Sergey Tkachenko** » Tue Aug 14, 2012 3:31 pm

If some RTF code cannot be loaded, please send it to a file and send to me by email.