working with footnote and editfootnote

alexandreq · Post by **alexandreq** » Sun Apr 08, 2012 7:42 pm

Hello Sergey,

I have a small project where I have three buttons, one for srvActionInsertFootnote1 another for srvActionEditNote1 and the last for srvActionEditMain1.

When I insert a footnote, it works perfectly. When I click the EditMain, it returns to my text without any problem, but when I need to reedit my note and I click the action EditNote, It open the footnote but it doesn't allow me to edit it. It seems that the text in footnote is readonly.

Why?

Thanks
Alexandre

alexandreq · Post by **alexandreq** » Sun Apr 08, 2012 11:28 pm

Just a comment

I noticed that not always happens.

Post by **Sergey Tkachenko** » Mon Apr 09, 2012 5:49 pm

Can you give me step-by-step instructions how to reproduce this?

alexandreq · Post by **alexandreq** » Wed Apr 11, 2012 2:51 pm

Hi Sergey,

I noticed that when I have a footnote and my cursor is on it this option srvActionEditNote1 becomes on. Then if I click on srvActionEditNote1, it goes to footnote. it is ok so far.

If I try to write the footnote, I can't. I can only write if my table is in state dsEdit or dsInsert.

My question:

When I click on the actionEditNote, shouldn't it goes to footnote allowing me to write?

Post by **Sergey Tkachenko** » Wed Apr 11, 2012 6:00 pm

This is a bug in TDBSRichViewEdit: a footnote/endnote editor cannot change the dataset to dsEdit state. It will be fixed in the next update (planned for tomorrow)

alexandreq · Post by **alexandreq** » Wed Apr 11, 2012 6:16 pm

Ok, Sergey.

Post by **Sergey Tkachenko** » Fri Apr 13, 2012 8:14 am

A fixed version is uploaded.

alexandreq · Post by **alexandreq** » Fri Apr 13, 2012 12:52 pm

Hello Sergey,

I download the updated:

* TRichView 13.10
* RichViewActions 3.6

I updated my code and I still have the same problem.

When I click on my button that has srvActionEditNote1, it goes to footnote but doesn't change the table state to dsEdit.

Post by **Sergey Tkachenko** » Fri Apr 13, 2012 5:48 pm

You need to download and install ScaleRichView 4.6 as well.

alexandreq · Post by **alexandreq** » Fri Apr 13, 2012 6:15 pm

Ok, I am gonna do that.

Just one think,

The installation is trial, is it? is that the right download?

Post by **Sergey Tkachenko** » Fri Apr 13, 2012 6:29 pm

No. You have access to the protected ScaleRichView forum (it should be the last forum in the list). You can find the source code version here.

Or you can run ScaleRichView installer, it will check for new versions and download them if necessary.

alexandreq · Post by **alexandreq** » Fri Apr 13, 2012 6:35 pm

Yeah, I had made a mistake.

I downloaded the correct file

Thanks very much Sergey

It is ok now

) I have tested.